pYES2-EGFP-Nat vector (Cat. No.: V017948)

pYES2-EGFP-Nat7697 bp3006009001200150018002100240027003000330036003900420045004800510054005700600063006600690072007500oriISSURA3URA3 promoterTEF promoterNrsRTEF terminator2μ oriM13 oriGAL1 promoterT7 promoterGFP (S65T)CYC1 terminator

Basic Information

The plasmid pYES2-EGFP is a high-copy, episomal yeast expression vector. It utilizes the galactose-inducible GAL1 promoter to control the expression of Enhanced Green Fluorescent Protein (EGFP) in Saccharomyces cerevisiae. It carries both URA3 marker and Nourseothricin (NrsR) for yeast selection.

Name:
pYES2-EGFP-Nat
Antibiotic Resistance:
Ampicillin
Length:
7697 bp
Type:
Protein expression
Replication origin:
ori
Host:
Yeast
Selection Marker:
URA3 and NrsR
Promoter:
GAL1
5' Primer:
T7
Growth Strain(s):
DH10B
Growth Temperature:
37℃
$ 199.4
In stock, instant shipping
Buy one, get one free! (?)
Two tubes of lyophilized plasmid will be delivered, each tube is about 5µg.

Plasmid Protocol

Plasmid Reconstitution Protocol

  1. Centrifuge at 5,000×g for 5 min.
  2. Carefully open the tube and add sterile water to dissolve the DNA: add 20 μl for 5 μg plasmid, and 100 μl for 100 μg plasmid.
  3. Close the tube and incubate for 10 minutes at room temperature.
  4. Briefly vortex the tube and then do a quick spin to concentrate the liquid at the bottom. Speed is less than 5000×g.
  5. Store the plasmid at -20 ℃.
  6. The concentration of plasmid re-measurement sometimes differs from the nominal value, which may be due to the position of the lyophilized plasmid in the tube, the efficiency of the re-dissolution, the measurement bias, and adsorption on the wall of the tube, therefore, it is recommended to transform and extract the plasmid before using it

General Plasmid Transform Protocol

  1. Take one 100μl of the competent cells and thaw it on ice for 10min, add 2μl of plasmid, then ice bath for 30min, then heat-shock it at 42℃ for 60s, do not stir, and then ice bath for 2min.
  2. Add 900μl of LB liquid medium without antibiotics, and incubate at 37℃ for 45min (30℃ for 1-1.5 hours) with 180rpm shaking.
  3. Centrifuge at 6000rpm for 5min, leave only 100μl of supernatant to resuspend the bacterial precipitate and spread it onto the target plasmid-resistant LB plate.
  4. Invert the plate and incubate at 37℃ for 14h, or at 30℃ for 20h.
  5. Pick a single colony into LB liquid medium, add the corresponding antibiotics, incubate at 220rpm for 14h, and extract the plasmid according to the experimental needs and the instructions of the plasmid extraction kit.

pYES2-EGFP-Nat vector (Cat. No.: V017948) Annotation

LOCUS       .                       7697 bp    DNA     circular UNK 01-JAN-1980
DEFINITION  synthetic circular DNA.
ACCESSION   
VERSION     
KEYWORDS    .
SOURCE      .
  ORGANISM  .
            .
FEATURES             Location/Qualifiers
     rep_origin      complement(237..825)
                     /label="ori"
                     /note="high-copy-number ColE1/pMB1/pBR322/pUC origin of
                     replication"
     misc_feature    complement(1294..1672)
                     /label="ISS"
                     /note="immunostimulatory sequence from the AmpR gene;
                     contains unmethylated CpG dinucleotides in the context of
                     5'-AACGTT-3' (Sato et al., 1996)"
     CDS             complement(1955..2755)
                     /label="URA3"
                     /note="orotidine-5'-phosphate decarboxylase, required for
                     uracil biosynthesis"
     promoter        complement(2756..2976)
                     /label="URA3 promoter"
     promoter        2985..3328
                     /label="TEF promoter"
                     /note="Ashbya gossypii TEF promoter"
     CDS             3348..3911
                     /label="NrsR"
                     /note="nourseothricin acetyltransferase"
     terminator      3929..4126
                     /label="TEF terminator"
                     /note="Ashbya gossypii TEF terminator"
     rep_origin      complement(4723..5603)
                     /label="2μ ori"
                     /note="yeast 2μ plasmid origin of replication"
     rep_origin      complement(5614..6127)
                     /label="M13 ori"
                     /note="M13 bacteriophage origin of replication; arrow
                     indicates direction of (+) strand synthesis"
     promoter        6146..6588
                     /label="GAL1 promoter"
                     /note="inducible promoter, regulated by Gal4"
     promoter        6620..6638
                     /label="T7 promoter"
                     /note="promoter for bacteriophage T7 RNA polymerase"
     CDS             6670..7383
                     /label="GFP (S65T)"
                     /note="S65T variant of Aequorea victoria green fluorescent
                     protein (Heim et al., 1995)"
     terminator      7446..7693
                     /label="CYC1 terminator"
                     /note="transcription terminator for CYC1"